A Hyundai Oil Change is a standard service performed on most automobiles, typically at an independent auto repair shop. Many consumers need to become more familiar with the Hyundai Oil Change process, and below is a list of the steps taken during an oil change.
- Shut off the car’s engine.
The first step to performing an oil change is ensuring the car is off and parked on a level surface. It is preferred to have an automotive jack for safety purposes, but it is not required if other precautions are taken.
- Remove the oil filter.
After the car has been turned off, it is essential to locate the Hyundai Oil Filter and unscrew it using a filter wrench or by hand. Never reuse an old filter, which could cause motor damage and failure.
- Drain engine oil from the sump pan into the drain pan.
For safety, connecting a drain pan under the engine may be helpful while allowing the oil to drip into it. After approximately three quarts of oil have dripped, you can stop the flow by covering the open hole with a rag to soak up any additional oil in the pan.
- Add new specification-level motor oil.
A funnel can add new motor oil into the engine after cleaning out old and filling it with new (4.5 or five quarts). It is essential to read the engine oil level soon after this step.
- Reinstall the oil filter.
After adding the proper amount of oil, you must put the new filter in place and tighten it with a filter wrench. It should be tightened directly when hand tightening will not tighten any further. Dirt may have collected significantly around the rim of the sump pan if you are changing your oil in an area that does not have many paved parking areas.
- Make sure all fittings are properly tightened.
Next, you must ensure all the hoses, including the one from the oil filter and the one from the oil sump pan, have been tightened. This is important to avoid any leaks in your engine.
- Start your engine and allow it to idle for a few minutes.
Once you have completed the previous steps, starting your engine and allowing it to idle for a few minutes before driving off is essential. This allows enough time for the oil pump and pressure to circulate through everything before driving off. If this is not done, you run an increased risk of damaging your vehicle during operation.
- Turn on the air conditioning and heater.
It is necessary to turn the air conditioning and heat on once you begin driving after changing your oil. Failure to do so can result in further engine damage.
- Drive off and check for leaks.
It is essential to drive your vehicle for a few minutes before checking for leaks as this will allow the oil to circulate, seeping out through all joints, hoses, seals and gaskets before going into your engine’s main parts where it would be tough to detect.
Conclusion
In conclusion, there are many different ways to perform Hyundai oil change. It is also important to remember that prevention is always better than a cure, and taking preventative measures may help keep your Hyundai in better condition for extended periods.
